A battery management system (BMS) is the small electronic board that sits between a rechargeable battery and everything it powers. It watches every cell, keeps the battery inside its safe limits, and tells the rest of the system how much energy is left.
Every phone, laptop, drone, e-bike and electric car has one. Without it, a lithium battery wears out quickly, gives wrong readings, and in the worst case overheats or catches fire.
Why does a battery need one?
When your phone shows 0 %, the battery is not really empty. The BMS stops it there because going lower would damage the cells. Lithium cells are happy only inside a narrow window of voltage, current and temperature, and the BMS is the part that keeps them inside it.
The four jobs of a BMS
1. Protection
The BMS switches the battery off before damage happens:
- Over-charge: a cell is pushed above its maximum voltage.
- Over-discharge: a cell is drained below its minimum voltage.
- Over-current: more current is drawn or pushed than the cells can take, including short circuits.
- Temperature: the pack is too hot, or too cold to be charged safely.
2. Fuel gauge (state of charge and health)
A battery cannot report its own charge level. Only voltage, current and temperature can be measured, so the BMS has to estimate the state of charge (SOC), how full the battery is, and the state of health (SOH), how much capacity is left compared to when it was new. A good estimate is the difference between “30 % left” meaning 30 minutes or meaning 3.
3. Cell balancing
A pack with several cells in series is only as good as its weakest cell. No two cells are identical, and over time they drift apart: one fills up first while the others are still charging. Balancing bleeds a little energy from the higher cells so that all cells end up at the same level, and the whole pack can be used.
4. Communication
The BMS reports voltages, current, temperature, state of charge and faults to the device, the charger or a PC, so the system can react: show the battery level, slow down the motor, or stop charging.
Where is a BMS used?
Anywhere a rechargeable lithium battery is used: phones, laptops, power tools, drones, e-scooters, e-bikes, solar storage, robots, IoT devices and electric cars.
Why OpenBMS?
Most BMS boards are closed: you cannot see how they estimate the charge, you cannot change the limits, and you cannot fix them. OpenBMS is fully open, from the schematics to the firmware, so you can see exactly what protects your battery and adapt it to your project.
Get started with OpenBMS →